Gas Detector Replacement Parts

Can charge a Tiger XT lithium ion battery in just 8 hours. It can charge battery packs separately or connected to the instrument.

Filter clamp holds the PTFE filter in place and ensures an air tight seal in conjunction with the O-ring.

Offers up to 24 hours of continuous use.

The sensor cover is screwed to the back of the Tiger XT models to protect the MiniPID 2.

The probe attaches easily and securely to the end of the instrument.

Fast direct connection between the Tiger instrument range and a computer.

Connects to a typical 1/4

Screws into the exhaust port of the instrument allowing gas to be captured into a sample bag via typical 1/4 ID pipe.

Ensures the filter clamp is held in place ensuring a leak tight seal.

For use with the charge cradle, allows direct connection with UK, US, EU and AUS power sockets.

Used to make an air tight seal ensuring all gas passes through the PTFE filter.

The probe seal sits in the filter clamp to keep it air tight.

Used to protect the instrument from debris and water ingress.

Used for MiniPID 2 10.0 eV Sensor. Found in Tiger XT Select, Cub TAC and can also be used in Tiger XT with 10.0 eV configuration.

Ensures rapid detection and selective measurement of benzene and attaches to the Tiger XT Select via the tube holder.

Designed to hold the benzene tubes securely onto the end of the Tiger XT Select.

Designed to safely break the glass tip off the benzene tube and stores it in the container.

The lamp spring ensures the lamp stays tightly coupled with the electrode stack.

The screw is used to keep the sensor cover attached to the back of the Tiger models.